That is the method that we used to make our rabbit foot key-chains.
Reading: How to make rabbit foot
You may as well see the video model of this How-To right here: How to make a rabbit foot key chain
Gadgets wanted: (affiliate hyperlinks under)
Rabbit toes
70% isopropyl alcohol (rubbing alcohol) Get It Right here
Borax Get It Right here
Water
Jar/container Get It Right here
Also Read: When to sow carrot seeds
Bells or finish caps Get It Right here
Key chain attachment or ball chain Get It Right here
Epoxy Get It Right here
Pliers Get It Right here
Discover rabbit toes: We’ve got meat rabbits that we additionally use for rabbit foot key-chains and fur. Lower the toes to the specified size. I hold mine so long as I can, chopping them as shut to the joint as potential. We used a pruning sheers to reduce the toes.
Also Read: Best trees to plant in florida
Wash toes: Wash the toes with heat water and dish cleaning soap. Repeat the method 2 or 3 occasions till they’re clear. Rinse properly after washing.
First soak: Discover a jar and a few 70% Isopropyl Alcohol (rubbing alcohol). Put the entire toes into the jar and add the rubbing alcohol till the toes are fully coated. Preserve the toes on this soak for 48 hours.
Rinse totally: Rinse the toes with water till the entire alcohol is eliminated. Squeeze the water out of the toes as a lot as you possibly can.
Also Read: Raised bed gardening on a hillside
Second soak: When you have a second jar, it can save you the alcohol for the subsequent time that you just course of toes. In any other case, rinse the alcohol out the jar, put the toes into the jar, and add water and borax. The quantity of borax will depend upon what number of toes you’re processing. Dissolve as a lot of the borax within the water as you possibly can (the borax could not all dissolve and that’s okay). Preserve the toes on this resolution for twenty-four hours.
Rinse totally: Rinse the toes once more with water ensuring to take away the entire borax. Squeeze out any extra water.
Dry the toes: I hung my toes to dry them however I’ve additionally seen individuals use a cooling rack from the kitchen. Dry the toes for 24-48 hours.
Prep the bells: Take pliers and open the jingle bells to take away the little ball that’s inside. Pry open the entire sides of the bell in order that the rabbit foot can slide into the bell. Finish caps will also be bought in several designs if you happen to select.
Attaching the ball chain: On the high of the bell there’s a little gap to connect the ball chain or key ring. I hooked up my ball chains earlier than including the epoxy to make certain that the opening didn’t get closed up by the epoxy.
Epoxy: I made certain that every one of my toes would match into the bell earlier than including the epoxy. Add a small quantity of epoxy within the bell the place the foot will go. Push the foot as far into the bell as potential. Let the epoxy dry for so long as the packaging recommends.
Pinch closed: End your toes by closing the bell together with your pliers so the bell sides squeeze tight in opposition to the foot.
To observe a video on this course of click on on the hyperlink Blissful Hills Homestead Rabbit foot key chain
Also Read: Best trees to plant in florida
